Getting Started with your SnapPocket Light

SnapPocket Light works on any smartphone except for flip phones. It attaches magnetically to MagSafe-compatible smartphones, magnetic phone cases, or you may purchase a Magnetic Sticker to turn any non-MagSafe phone or phone case into a magnetic one.

Step 1: Attach the SnapPocket Light to your smartphone.

a. For MagSafe-compatible smartphones and magnetic phone cases: Attach the SnapPocket Light directly to the back of your phone. It will snap into place securely.

b. For non-MagSafe smartphones: Attach the magnetic sticker to either the back of your smartphone or at the back of your phone case. Once the magnetic sticker is attached, place the SnapPocket Light on top of the magnetic sticker. It will snap into place either on the phone or the phone case, depending on where you attached the sticker.

Step 2

Turn on the SnapPocket Light by locating the power button and performing a long press.

Step 3

To adjust the brightness of the SnapPocket Light, press the button once at a time. Each press will cycle through the available brightness levels.

Note: The SnapPocket Light offers four (4) levels of brightness for you to choose from.

Charging the SnapPocket Light: 

Step 1: Locate the charging port

The charging port is located below the power button on the inside of the SnapPocket Light. 

Step 2: Insert the charging cable.

Take a USB-C charging cable and insert one end into a compatible power source, such as a USB wall adapter or a computer's USB port. Insert the other end of the charging cable into the charging port of the SnapPocket Light. Ensure that the connection is secure.

Step 3: Monitor the charging process.

Once the SnapPocket Light is connected to the power source, a charging indicator will appear, this is a blinking green LED light. This indicates that the SnapPocket Light is successfully charging.

Step 4: Allow time to charge. 
Let the SnapPocket Light charge for the recommended amount of time, which is usually indicated in the product manual. Once the SnapPocket Light is fully charged, the LED light will stop blinking and turn solid green. Disconnect the charging cable from both the SnapPocket Light and the power source. Your SnapPocket Light is now ready to use.