Getting Started with your TravelPod Pro

TravelPod Pro is an all-in-one Tripod, Monopod, and Selfie Stick solution for all content creators.

I. Using TravelPod Pro as a tripod.

Step 1: Unfold the TravelPod Pro leg to your desired width and press the angle adjustment button to adjust the height levels.

Step 2: Extend the legs of the tripod.

a. Unlock the rubber foot pads.

b. Pull down each section until they are fully extended

c. Turn the rubber foot pad to the right, securely locking the legs in place

Step 3: Extend the height of the tripod.

a. Twist the ball locking knob to the left

b. Pull up to extend the height of the tripod to your desired length

c. Securely lock the knob by turning it to the right

Step 4: You are ready to attach your smartphone, ProGrip, or DLSR to the tripod

a. To attach the DLSR:

• Line up the 1/4 screw found on the camera platform with the bottom of the camera
• Once they are lined up, screw them together by using the dial on the side of the camera platform
• Adjust the camera position by loosening the ball-locking knob
• Securely lock the knob once you've found your desired position

b. To attach the ProGrip:

• Line up the 1/4 screw found on the camera platform with the screw thread of the ProGrip
• Once they are lined up, screw them together by using the dial on the side of the camera platform
• Adjust the ProGrip position by loosening the ball-locking knob
• Securely lock the knob once you've found your desired position

c. To attach the smartphone:

• Transform the camera platform into a smartphone clamp by flipping open the clamp wings
• Adjust the smartphone's position by loosening the ball-locking knob
• Securely lock the knob once you've found your desired position

 

II. Using TravelPod Pro as a monopod and selfie stick.

Step 1: Open the tripod legs and unscrew the center column locking knob

Step 2: Push the top column down between the legs, then unscrew and remove the detachable bottom cap to remove the tripod legs completely.

Step 3: Re-attach the bottom cap, then adjust the length of the monopod or selfie stick by twisting the ball head to the left and pulling it apart.

 

Step 4: Once you've reached your desired height or length, tighten the head again by twisting the ball head to the right.

Step 5: Attach your smartphone and you are now ready to use your monopod or selfie stick.

As your visual guide, you can also watch the TravelPod Pro tutorial video on this link: TravelPod Pro Guide.

Tips and Tricks: The TravelPod Pro doesn't have a shutter button. However, if you own a ProGrip or SnapGrip, you can use them as your shutter while your smartphone is attached to the TravelPod Pro. Alternatively, you can set a timer on your smartphone when using the TravelPod Pro as a monopod or selfie stick.

Reminder: The TravelPod Pro's maximum load is 3kg only.